Knowledgebase
How to get started?
Posted by - NA - on 20 October 2008 08:23 PM

1. Run AnyMem 2.0.
2. Connect to the document you are going to translate by clicking the menu Document > Connect.
3. Load the appropriate translation memory, or create a new translation memory by clicking the menu Memory > Open or Memory > New accordingly.
4. Begin translation

(2 vote(s))
Helpful
Not helpful

Comments (0)
Post a new comment
 
 
Full Name:
Email:
Comments:
CAPTCHA Verification 
 
Please enter the text you see in the image into the textbox below (we use this to prevent automated submissions).